Wiper And Washer System (W/O Rain Sensor) - Terminals Of Ecu
Disconnect the L50 and L51 No. 2 multiplex network body ECU connectors.
Wiper And Washer System (W/O Rain Sensor) - Problem Symptoms Table
Land Cruiser URJ200 URJ202 GRJ200 VDJ200 WIPER / WASHER
Wiper And Washer System (W/O Rain Sensor) - How To Proceed With Troubleshooting
Measure the battery voltage with the ignition switch off.
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
Wiper And Washer System (W/O Rain Sensor) - System Description
This system operates the front wipers at low speed immediately after a jet of washer fluid when the front washer switch is turned on for 0.3 seconds or more. The system operates the front wipers at low speed for approximately 2.2 seconds and then stops operation when the washer switch is turned on for 1.5 seconds or more.
Wiper And Washer System (W/O Rain Sensor) - System Diagram
Land Cruiser URJ200 URJ202 GRJ200 VDJ200 WIPER / WASHER
Wiper And Washer System (W/O Rain Sensor) - Parts Location
Land Cruiser URJ200 URJ202 GRJ200 VDJ200 WIPER / WASHER
Wiper And Washer System (W/O Rain Sensor) - Precaution
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Wiper And Washer System (W/ Rain Sensor) - Ecu Power Source Circuit
This circuit provides power to the windshield wiper ECU and operates the front wiper motor.
Wiper And Washer System (W/ Rain Sensor) - Washer Nozzle Heater Circuit
The No. 2 multiplex network body ECU receives ambient air temperature information from the air conditioning amplifier assembly via CAN communication.
The washer nozzle heater assembly controls the No. 2 multiplex network body ECU and operates the washer nozzle heater assembly according to the ambient temperature.