Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - WIPER / WASHER


WIPER AND WASHER SYSTEM (w/o Rain Sensor) - HOW TO PROCEED WITH TROUBLESHOOTING

  • HINT:
Use the following procedure to troubleshoot the wiper and washer system.
*: Use the intelligent tester.

1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
NEXT
3.INSPECT BATTERY VOLTAGE

Measure the battery voltage with the ignition switch off.

  • Standard voltage:
  • 11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


NEXT
4.PROBLEM SYMPTOMS TABLE

Refer to the Problem Symptoms Table ().

Result
ResultProceed to
Fault is not listed in Problem Symptoms TableA
Fault is listed in Problem Symptoms TableB
B.
ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
A
5.OVERALL ANALYSIS AND TROUBLESHOOTING*

Data List / Active Test ().

Terminals of ECU ().

Inspection.

On-vehicle inspection.

NEXT
6.ADJUST, REPAIR OR REPLACE
NEXT
7.CONFIRMATION TEST
NEXT
END
WIPER / WASHER
Land Cruiser URJ200 URJ202 GRJ200 VDJ200
WIPER AND WASHER SYSTEM w/o Rain Sensor