Diagnostic trouble code chart. Anti-lock Brake System. Land Cruiser.
Table of diagnostic error codes for Toyota RAV4 ABS
HINT:
- If there are no malfunctions during the inspection of parts, check the ECU of the anti-skid system and the contact of the connection points with the ground.
- If an error code appears on the display when checking for errors, check the corresponding circuit shown in the following table. A description of each error code is provided on the specified page.
- If 2 or more error codes are registered, check the circuits sequentially until the fault is identified.
- All error codes in the following table are registered in accordance with the diagnostic logic for 1 trip.
Toyota ABS Error Number | Toyota ABS malfunction | Toyota's faulty ABS error section |
C0200 *1 | Front right wheel speed sensor signal | - Front speed sensor-Front speed sensor circuit - Sensor mounting - Foreign particles on the sensor rotor |
C0205 *1 | Front left wheel speed sensor signal | - Front speed sensor-Front speed sensor circuit - Sensor mounting - Foreign particles on the sensor rotor |
C0210 *1 | Rear right wheel speed sensor signal | - Rear speed sensor-Rear speed sensor circuit - Sensor mounting - Foreign particles on the sensor rotor |
C0215 *1 | Rear left wheel speed sensor signal | - Rear speed sensor-Rear speed sensor circuit - Sensor mounting - Foreign particles on the sensor rotor |
C0226 | SFR Solenoid Valve Circuit | - ABS actuator and anti-slip system |
C0236 | SFL Solenoid Valve Circuit | - ABS actuator and anti-slip system |
C0246 | SRR solenoid valve circuit | - ABS actuator and anti-slip system |
C0256 | SRL Solenoid Valve Circuit | - ABS actuator and anti-slip system |
C0273 *1 | ABS motor relay circuit break | - High-amp fuse ABS1 - VSC MTR relay-VSC MTR relay circuit-VSC FAIL relay-VSC FAIL relay circuit -ABS and anti-slip system actuator |
C0274 | Short circuit to B+ in the ABS motor relay circuit | - High-amp fuse ABS1 - VSC MTR relay-VSC MTR relay circuit-VSC FAIL relay-VSC FAIL relay circuit -ABS and anti-slip system actuator |
C0278 | ABS solenoid valve relay circuit break | - High-amp fuse ABS2 -Wiring harness (circuit +BS) - ABS actuator and anti-slip system |
C0279 | Short circuit to B+ in the ABS solenoid valve relay circuit | - High-amp fuse ABS2 -Wiring harness (circuit +BS) - ABS actuator and anti-slip system |
C1225 | SM solenoid valve circuit | - ABS actuator and anti-slip system |
C1235 | Foreign particles on the tip of the front right speed sensor | - Front speed sensor - Front speed sensor circuit - Sensor mounting |
C1236 | Foreign particles on the tip of the front left speed sensor | - Front speed sensor - Front speed sensor circuit - Sensor mounting |
C1238 | Foreign particles on the tip of the rear right speed sensor | - Rear speed sensor - Rear speed sensor circuit - Sensor mounting |
C1239 | Foreign particles on the tip of the rear left speed sensor | - Rear speed sensor - Rear speed sensor circuit - Sensor mounting |
C1241 | Low positive battery voltage | - Battery pack - Charging system - Power supply circuit - Internal power supply circuit of the ECU of the anti-skid system |
C1243 *1 | Jamming in the deceleration sensor | - Yaw sensor -Yaw sensor circuit |
C1244 | Open or short circuit in the deceleration sensor circuit | - Yaw sensor -Yaw sensor circuit |
C1245 *1 | Abnormal acceleration sensor output | - Yaw sensor -Yaw sensor circuit |
C1246 *2 | Main cylinder pressure sensor malfunction | - Master cylinder pressure sensor-Master cylinder pressure sensor circuit -Brake light switch circuit - ABS and traction control actuator |
C1249 | Open circuit of the brake light switch | - STOP fuse - Brake light switch-Brake light switch circuit - ABS and anti-slip system actuator |
C1251 *1 | Pump motor circuit failure | - Wiring harness -ABS actuator and anti-slip system |
C1267 *3 | Brake pedal load relay | - Brake pedal load relay -Brake pedal load relay circuit |
C1337 | Incorrect tire diameter | - Tire size |
C1361 | Short circuit in the motor emergency relay circuit ABS | - High-amp fuse ABS1 - VSC MTR relay-VSC MTR relay circuit-VSC FAIL relay-VSC FAIL relay circuit -ABS and anti-slip system actuator |
C1381 | Invalid power supply voltage of the deceleration and/or yaw sensor | - Yaw sensor -Yaw sensor circuit |
U0073 | The control unit data bus is disabled | - Multiplex CAN bus |
HINT:
*1, *2
Even after troubleshooting, the ABS warning light turns off only after performing the following operations.
- *1:
- Drive the vehicle at 20 km / h (12 mph) for 30 seconds and make sure that the ABS warning light is off.
- Reset the error codes.
- *2:
- Stop the car for 5 seconds or more and lightly press the brake pedal 2-3 times.
- When driving at a speed of 50 km/h (31 miles per hour), hold the brake pedal firmly for approximately 3 seconds.
- Repeat the specified operation at least 3 times and make sure that the ABS warning light is turned off.
- Reset the error codes .
- *3: 16-inch disk
Toyota ABS Sensor Check Function Errors
Toyota ABS sensor error Number | Toyota ABS malfunction | Toyota's faulty ABS section |
C1271 | Weak output signal of the front right speed sensor (Active diagnostic mode error) | - Front speed sensor-Front speed sensor circuit - Sensor mounting - Foreign particles on the sensor rotor |
C1272 | Weak output signal of the front left speed sensor (Active diagnostic mode error) | - Front speed sensor-Front speed sensor circuit - Sensor mounting - Foreign particles on the sensor rotor |
C1273 | Weak output signal of the rear right speed sensor (Active diagnostic mode error) | - Rear speed sensor-Rear speed sensor circuit - Sensor mounting - Foreign particles on the sensor rotor |
C1274 | Weak output signal of the rear left speed sensor (Active diagnostic mode error) | - Rear speed sensor-Rear speed sensor circuit - Sensor mounting - Foreign particles on the sensor rotor |
C1275 | Abnormal change in the output signal of the front-right speed sensor (Active diagnostic mode error) | - Front speed sensor - Front speed sensor circuit - Sensor mounting |
C1276 | Abnormal change in the output signal of the front left speed sensor (Active diagnostic mode error) | - Front speed sensor - Front speed sensor circuit - Sensor mounting |
C1277 | Abnormal change in the output signal of the rear right speed sensor (Active diagnostic mode error) | - Rear speed sensor - Rear speed sensor circuit - Sensor mounting |
C1278 | Abnormal change in the output signal of the rear left speed sensor (Active diagnostic mode error) | - Rear speed sensor - Rear speed sensor circuit - Sensor mounting |
C1279 | Invalid deceleration sensor output voltage (Active diagnostic mode error) | - Yaw sensor -Yaw sensor circuit |
C1281 | Invalid signal at the output of the master cylinder pressure sensor (Active diagnostic mode error) | - Master cylinder pressure sensor-Master cylinder pressure sensor circuit -Brake light switch circuit - ABS and traction control actuator |
U0124 | Communication failure with the lateral acceleration sensor | - Multiplex CAN bus (between the anti-skid control unit and the deceleration and yaw sensor) |
HINT:
The codes shown in this table are displayed only in active diagnostic mode.