Dtc C1626 Steering Angle Sensor Failure


DESCRIPTION

INSPECTION PROCEDURE

REPLACE SPIRAL CABLE SUB-ASSEMBLY

CHECK FOR DTC

DTC C1626 Steering Angle Sensor Failure


DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral cable sub-assembly that indicates an internal malfunction.

DTC Code
DTC Detection Condition
Trouble Area
C1626
A fail flag is transmitted from the steering angle sensor.
  1. Spiral cable sub-assembly
  2. Parking assist ECU

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (LandCruiser RM0000035DE05TX.html).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (LandCruiser RM0000035DD06LX.html).
1.REPLACE SPIRAL CABLE SUB-ASSEMBLY

  1. Replace the spiral cable sub-assembly with a normally functioning one (LandCruiser RM000002O8X02DX.html).


NEXT


2.CHECK FOR DTC

  1. Clear the DTCs (LandCruiser RM0000035DB07DX.html).

  1. Check for DTCs (LandCruiser RM0000035DB07DX.html).

    OK:
    DTC C1626 is not output.
Result
Proceed to
Result
OK
A
NG (for LHD)
B
NG (for RHD)
C


B
REPLACE PARKING ASSIST ECU (LandCruiser RM00000466X026X.html)

C
REPLACE PARKING ASSIST ECU (LandCruiser RM00000470500OX.html)
A

END (SPIRAL CABLE SUB-ASSEMBLY IS DEFECTIVE)