Vehicle Stability Control System (For Vacuum Brake Booster) Trc Off Indicator Light Remains On
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK CAN COMMUNICATION SYSTEM
INSPECT VSC OFF SWITCH
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH)
READ VALUE USING INTELLIGENT TESTER (TRC/VSC OFF MODE)
VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster) - TRC OFF Indicator Light Remains ON |
DESCRIPTION
The skid control ECU is connected to the combination meter via the CAN communication system.Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls. If traction control turns off, the TRC OFF indicator light comes on.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (LandCruiser RM000000XHR0BKX.html).
- As there may be malfunctions in the transfer system related to when the transfer operates in L4, check the transfer system first (LandCruiser RM0000030AI01JX.html).
1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (for LHD without Entry and Start System: LandCruiser RM000000WIB0EDX.html, for LHD with Entry and Start System: LandCruiser RM000000WIB0ECX.html).
ResultResult
| Proceed to
|
DTC not output
| A
|
DTC output
| for LHD without Entry and Start System
| B
|
DTC output
| for LHD with Entry and Start System
| C
|
Remove the VSC OFF switch (LandCruiser RM000001WZ2051X.html).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Switch Condition
| Specified Condition
|
6 - 3
| Switch is not pushed
| 10 kΩ or higher
|
Switch is pushed
| Below 1 Ω
|
Text in Illustration*a
| Component without harness connected (VSC OFF Switch)
|
3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Disconnect the A6 skid control ECU connector.
Disconnect the G9 VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
A6-30 (CSW) - G9-6
| Always
| Below 1 Ω
|
A6-30 (CSW) - Body ground
| Always
| 10 kΩ or higher
|
G9-3 - Body ground
| Always
| Below 1 Ω
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
4.READ VALUE USING INTELLIGENT TESTER (TRC/VSC OFF MODE) |
Turn the ignition switch off.
Connect the Intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRCTester Display
| Measurement Item/Range
| Normal Condition
| Diagnostic Note
|
TRC/VSC Off Mode
| TRC/VSC off mode/ Normal, TRC OFF or VSC OFF
| Normal: Normal mode TRC OFF: TRC OFF mode VSC OFF: VSC OFF mode
| -
|
Check that the mode display changes according to VSC OFF switch operation.
- OK:
- Display changes according to switch operation.