DTC P0657 Actuator Supply Voltage Circuit / Open Monitor description Monitor strategy Typical enabling conditions Typical malfunction thresholds Confirmation driving pattern Inspection procedure Read output dtc (dtc p0657)

DTC P060E Internal Control Module Throttle Position Performance Monitor description Monitor strategy Typical enabling conditions Typical malfunction thresholds Confirmation driving pattern Inspection procedure Read output dtc (dtc p060e)

DTC P060B Internal Control Module A/D Processing Performance Description Monitor strategy Confirmation driving pattern Inspection procedure Read output dtc (dtc p060b)

DTC P060A Internal Control Module Monitoring Processor Performance Monitor description Monitor strategy Confirmation driving pattern Inspection procedure Read output dtc (dtc p060a)

DTC P0606 ECM / PCM Processor Monitor description Monitor strategy Confirmation driving pattern Inspection procedure Read output dtc (dtc p0606)

DTC P0604 Random Access Memory (RAM) Monitor description Monitor strategy Confirmation driving pattern Inspection procedure Read output dtc (dtc p0604)

DTC P0560 System Voltage Monitor description Monitor strategy Typical malfunction thresholds Confirmation driving pattern Wiring diagram Inspection procedure Check harness and connector (ecm - auxiliary battery) Inspect auxiliary battery Check auxiliary battery terminal Check whether dtc output recurs

DTC P0505 Idle Control System Malfunction Description Monitor description Monitor strategy Typical malfunction thresholds Confirmation driving pattern Inspection procedure Check any other dtcs output (in addition to dtc p0505) Check pcv hose connections Check intake system Perform active test using intelligent tester (control the egr step position) Inspect egr valve assembly Inspect throttle body assembly Confirm whether malfunction has been successfully repaired

DTC P0443 Evaporative Emission Control System Purge Control Valve Circuit Description Confirmation driving pattern Wiring diagram Inspection procedure Perform active test using intelligent tester (activate the vsv for evap control) Inspect purge vsv Check purge vsv (power source voltage) Check harness and connector (purge vsv - ecm)

Turn the power switch on (IG). Turn the tester on. Clear the DTCs (even if no DTCs are stored, perform the clear DTC operation). Turn the power switch off and wait for at least 30 seconds. Turn the power switch on (IG) and turn the tester on. Put the engine in inspection mode (maintenance mode) . Start the engine and warm it up until the engine coolant temperature is 75°C (167°F) or higher [A].