DTC P0604 Random Access Memory (RAM)
Monitor description
The ECM continuously monitors its internal memory status. This self-check ensures that the ECM is functioning properly. It is diagnosed by internal "mirroring" of the main CPU and sub CPU to detect Random Access Memory (RAM) errors. If outputs from these CPUs are different and deviate from the standards, the ECM will illuminate the MIL and set the DTC immediately.
DTC No. | DTC Detection Condition | Trouble Area |
P0604 | ECM RAM errors (Main CPU and sub CPU mirroring failure) (1 trip detection logic). | ECM |
Monitor strategy
Required sensors/Components (Main) | ECM |
Frequency of operation | Continuous |
Confirmation driving pattern
- Turn the power switch off.
- Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) auxiliary battery terminal.
- Turn the power switch on (IG) and wait for 16 seconds or more.
Inspection procedure
NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work .
HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.
1.READ OUTPUT DTC (DTC P0604) |
-
Connect the intelligent tester to the DLC3.
-
Turn the power switch on (IG).
-
Turn the tester on.
-
Clear the DTCs .
-
Turn the power switch off and turn the tester off.
-
Disconnect the tester.
-
Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
-
Connect the cable to the negative (-) auxiliary battery terminal.
-
Connect the tester to the DLC3.
-
Turn the power switch on (IG).
-
Turn the tester on.
-
Wait 16 seconds or more.
-
Enter the following menus: Powertrain / Engine and ECT / DTC.
-
Read the DTCs.
Result Result Proceed to DTC is not output A DTC P0604 is output B
|
|
||||
A | |
|