DTC P060A 2ZR-FXE

DTC P060A Internal Control Module Monitoring Processor Performance

  1. Monitor description

  2. Monitor strategy

  3. Confirmation driving pattern

  4. Inspection procedure

  5. Read output dtc (dtc p060a)

Monitor description

The main CPU and sub CPU of the ECM communicate with each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below deviate, the DTC is stored.

DTC No. DTC Detection Condition Trouble Area
P060A A CPU reset is performed after one of the following conditions is met (1 trip detection logic):
  1. There is an ECM main CPU error.
  2. There is an ECM sub CPU error.
  3. There is an electronic throttle monitoring CPU error.
ECM

Monitor strategy

Required sensors/Components (Main) ECM
Frequency of operation Continuous

Confirmation driving pattern

  1. Turn the power switch off.
  2. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
  3. Connect the cable to the negative (-) auxiliary battery terminal.
  4. Turn the power switch on (IG) and wait for 10 seconds or more.

Inspection procedure

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work .

1.READ OUTPUT DTC (DTC P060A)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Clear the DTCs .

  1. Turn the power switch off.

  1. Disconnect the tester.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) auxiliary battery terminal.

  1. Connect the tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Wait 16 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result
    Result Proceed to
    DTC is not output A
    DTC P060A is output B
  B  
REPLACE ECM
 
A  
   
CHECK FOR INTERMITTENT PROBLEMS