DTC C1201 Malfunction of the engine management system
Description. DTC C1201
If a malfunction is detected in the engine management system, the fail-safe function disables the VSC and TRC.When the signals from the engine return to normal, the emergency mode is canceled and the DTC is not stored.
No. DTC | DTC detection condition | Faulty plot |
C1201/51 | The engine management system fault signal is stored for 5 seconds. | Engine management system |
Inspection procedure. DTC C1201
1.CHECK HARNESS AND CONNECTOR (FOR A MOMENTARY OPEN)
-
Use the Test Tool to check the Data List for a momentary open in the harness associated with the DTC.
Skid control ECU
Parameter / Device Measured variable / display range Normal condition Diagnostic note EFI Communication Open An open in the communication circuit EFI / ERROR (error) or NORMAL (normal condition) ERROR: momentary trip
NORMAL: no faults- OK:
No short breaks.
NOTE:
The check described above should be performed before removing the sensor and disconnecting the connector.
|
|
||||
OK | |
2.CHECK ENGINE CONTROL DTC |
-
Clear the DTC (engine management system).
-
Check DTC (Engine Control System).
Result
Result Next step DTC output BUT DTC is not output B
|
|
||||
BUT | |
|
3. REPAIR OR REPLACE HARNESS AND CONNECTOR (ECM - SKID CONTROL ECU)
FURTHER | |
4.CHECK DTC AGAIN
-
Clear the DTC.
-
Do a road test.
-
Check if the same DTC is logged.
Result
Result Next step DTC is not output BUT DTC C1201/51 is output B
|
|
||||
BUT | |
|