Skid Control Buzzer Removal
Brake. Lexus Is250, Is220D. Gse20 Ale20
PRECAUTION
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE SIDE INSTRUMENT PANEL LH
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
REMOVE LOWER INSTRUMENT FINISH PANEL SUB-ASSEMBLY
REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
REMOVE SKID CONTROL BUZZER ASSEMBLY
Skid Control Buzzer -- Removal |
- CAUTION:
- Be sure to read the "PRECAUTION" thoroughly before servicing (Click here).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE SIDE INSTRUMENT PANEL LH |
Using a moulding remover, disengage the 5 claws and 3 clips, and then remove the side instrument panel LH.
4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Remove the 2 screws <E>.
Push the 2 claws in the direction indicated by the arrow to disengage them.
Remove the No. 1 instrument panel under cover sub-assembly from the guide as shown in the illustration and pull the cover toward the rear of the vehicle.
Disconnect the connectors and remove the No. 1 instrument panel under cover sub-assembly.
5. REMOVE LOWER INSTRUMENT FINISH PANEL SUB-ASSEMBLY |
Disengage the 7 clips.
Disconnect the connectors and remove the lower instrument panel finish panel sub-assembly.
6. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY |
Remove the 4 bolts and driver side knee airbag assembly.
Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
7. REMOVE SKID CONTROL BUZZER ASSEMBLY |
Remove the clip and skid control buzzer assembly.