Steering Column Assembly (For Manual Tilt And Manual Telescopic Steering Column) Installation

Align the part of the dust cover labeled A with the No. 2 steering intermediate shaft, and install the No. 2 steering intermediate shaft assembly to the steering link assembly.

Install the bolt.

Torque:

35 N*m{357 kgf*cm, 26 ft.*lbf}

NOTICE:

Be careful not to damage the dust cover.

Install the 4 bolts and nut.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

NOTICE:

Do not fold back the boot part of the steering hole cover or extend it excessively. if it is extended excessively, return it to its original position.

HINT:

Install the steering intermediate shaft assembly from the inside of the vehicle.

Using needle nose pliers, lock the clamp to the steering column hole cover to install it.

NOTICE:

Be careful when performing the operation as the clamp may not lock if the claws of the clamp are deformed.

Align the matchmarks on the No. 2 steering intermediate shaft assembly and the steering intermediate shaft assembly.

HINT:

Install the steering intermediate shaft from the inside of the vehicle.

Install the bolt.

Torque:

35 N*m{357 kgf*cm, 26 ft.*lbf}

Align the matchmarks on the steering intermediate shaft and the steering column.

Install the bolt.

Torque:

35 N*m{357 kgf*cm, 26 ft.*lbf}

w/o Entry and Start System:

1. Install the steering column with the 4 nuts.
   

   Torque:

   21 N*m{214 kgf*cm, 15 ft.*lbf}

w/ Entry and Start System

1. Install the steering column with the 4 nuts.
   

   Torque:

   26 N*m{265 kgf*cm, 19 ft.*lbf}

Attach the 2 claws to install the duct.

Install the clip.

Attach the 2 claws to connect the wire harness protector and wire harness.

Connect the 2 wire harness clamps.

Using pliers, grip the claws of the clamp and install the combination switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.

Connect the connectors to the combination switch with spiral cable.

Attach the claw to install the upper steering column cover.

Attach the 4 clips and 2 claws to install the upper steering column cover onto the meter hood spacer.

Attach the 2 claws to install the lower steering column cover.

Install the 3 screws.

Torque:

1.5 N*m{15 kgf*cm, 13 in.*lbf}