Anti-Lock Brake System Dtc Check / Clear

Brake. Camry. Acv40 Gsv40
Brake Control. Camry. Acv40 Gsv40

  1. DTC CHECK / CLEAR (SST CHECK WIRE)

  1. DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:)

  1. END OF DTC CHECK/CLEAR

Anti-Lock Brake System -- Dtc Check / Clear



DTC CHECK / CLEAR (SST CHECK WIRE)


    Camry. Acv40 Gsv40.Brake Control.Anti-Lock Brake System.Anti-Lock Brake System Dtc Check / Clear

  1. DTC check

    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040

    2. Turn the ignition switch to the ON position.

    3. Read the DTCs from the ABS warning light on the combination meter.

      HINT:
      If no code appears, inspect the TC and CG terminal circuit and the ABS warning light circuit.
      Trouble Area
      		See procedure
      TC and CG terminal circuit
      		CAMRY_ACV40 RM000000XQU00SX.html
      ABS warning light circuit (Remains on)
      		CAMRY_ACV40 RM000001JD300MX.html
      ABS warning light circuit (Does not come on)
      		CAMRY_ACV40 RM000001JD400MX.html


    4. As an example, refer to the chart below for the blinking patterns of the normal system code and trouble codes 11 and 21.


      Camry. Acv40 Gsv40.Brake Control.Anti-Lock Brake System.Anti-Lock Brake System Dtc Check / Clear

    5. The codes are explained in the code table (CAMRY_ACV40 RM000001JB200XX.html).

    6. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.



    2. Camry. Acv40 Gsv40.Brake Control.Anti-Lock Brake System.Anti-Lock Brake System Dtc Check / Clear

  2. DTC clear

    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040

    2. Turn the ignition switch to the ON position.



      3. Camry. Acv40 Gsv40

    3. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    4. Check that the warning light indicates the normal system code.

    5. Remove the SST from the terminals of the DLC3.

      HINT:
      Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.

DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:)


    Camry. Acv40 Gsv40.Brake Control.Anti-Lock Brake System.Anti-Lock Brake System Dtc Check / Clear

  1. DTC check

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Read the DTCs by following the prompts on the tester screen.

  2. DTC clear

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Operate the intelligent tester to clear the codes.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

END OF DTC CHECK/CLEAR

  1. Turn the ignition switch to the ON position.

  2. Check that the ABS warning light goes off within approximately 3 seconds.