Dtc C1282 Center Differential Lock Position Switch
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT CENTER DIFFERENTIAL LOCK SHIFT
CHECK TEST MODE DTC
CHECK TERMINAL VOLTAGE (EXI4)
CHECK TEST MODE DTC
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FOUR WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR)
DTC C1282 Center Differential Lock Position Switch |
DESCRIPTION
DTC C1282 is stored only in test mode.DTC Code
| DTC Detection Condition
| Trouble Area
|
C1282
| Stored during test mode.
| - Harness or connector
- Transfer system
- Brake actuator assembly (Skid control ECU)
|
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (LandCruiser RM000000XHR0BKX.html).
1.INSPECT CENTER DIFFERENTIAL LOCK SHIFT |
Check that the center differential can shift from free to lock, and from lock to free.
- OK:
- The center differential can shift from free to lock, and from lock to free.
Switch the vehicle to test mode, perform the center differential lock signal check, and then check that DTC C1282 is cleared (LandCruiser RM000000XHT0EPX.html).
ResultResult
| Proceed to
|
DTC is not cleared
| A
|
DTC is cleared
| B
|
3.CHECK TERMINAL VOLTAGE (EXI4) |
Set the vehicle in the center differential locked state using the center differential lock switch.
Disconnect the A6 skid control ECU connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Condition
| Specified Condition
|
A6-9 (EXI4) - Body ground
| Center differential locked (Center differential lock switch on)
| Below 1.5 V
|
Text in Illustration*a
| Front view of wire harness connector (to Skid Control ECU)
|
Connect the A6 skid control ECU connector.
Set the vehicle in the center differential free state using the center differential lock switch.
Disconnect the A6 skid control ECU connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Condition
| Specified Condition
|
A6-9 (EXI4) - Body ground
| Center differential free (Center differential lock switch off)
| 11 to 14 V
|
Switch the vehicle to test mode, perform the center differential lock signal check, and then check that DTC C1282 is cleared (LandCruiser RM000000XHT0EPX.html).
ResultResult
| Proceed to
|
DTC is not cleared
| A
|
DTC is cleared
| B
|
5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FOUR WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR) |
Disconnect the A6 skid control ECU connector.
Disconnect the G53 four wheel drive control ECU connector.
Disconnect the C43 transfer shift actuator connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
A6-9 (EXI4) - G53-14 (P1)
| Always
| Below 1 Ω
|
A6-9 (EXI4) - C43-9 (CDL)
| Always
| Below 1 Ω
|
A6-9 (EXI4) - Body ground
| Always
| 10 kΩ or higher
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|