Theft Deterrent System (W/ Entry And Start System) - Engine Hood Courtesy Switch Circuit
Using the intelligent tester, read the Data List.
Dtc B276A Short To Gnd In Tilt Sensor Signal Circuit
The yaw rate sensor conducts a self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
This DTC is stored when terminal CSIF of the yaw rate sensor has not received a signal for 5 seconds or more.
Dtc B2764 Short To Gnd In Intrusion Sensor Signal Circuit
Using an oscilloscope, check the waveform.
Dtc B2769 Tilt Sensor Signal Circuit Malfunction
The yaw rate sensor conducts a self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
If a malfunction is detected in the CSIF-CSIF line, the certification ECU (smart key ECU assembly) stores this DTC.
Dtc B2762 Intrusion Sensor Signal Circuit Malfunction
Disconnect the map light assembly connector.
Dtc B2768 Tilt Sensor Internal Circuit Malfunction
This DTC is stored when one of the following occurs: 1) yaw rate sensor power supply malfunction; 2) yaw rate sensor open malfunction; or 3) EEPROM malfunction.
Dtc B2761 Intrusion Sensor Internal Circuit Malfunction
Set the theft deterrent system and check if the same DTC is not output.
Theft Deterrent System (W/ Entry And Start System) - Diagnostic Trouble Code Chart
Land Cruiser URJ200 URJ202 GRJ200 VDJ200 THEFT DETERRENT / KEYLESS ENTRY
Theft Deterrent System (W/ Entry And Start System) - Data List / Active Test
Connect the intelligent tester to the DLC3.
Theft Deterrent System (W/ Entry And Start System) - Dtc Check / Clear
Connect the intelligent tester to the DLC3.