Crankshaft Position Sensor Installation

Apply a light coat of engine oil to the O-ring of the sensor.

Install the sensor with the bolt.

Момент затяжки:

8.8 Н*м{90 кгс*см, 78 фунт-сила-дюймов}

Connect the sensor wire harness clamp.

Connect the sensor connector to the bracket.

Connect the sensor connector.

Install the generator with the 3 bolts.

Момент затяжки:

25 Н*м{255 кгс*см, 18 фунт-сила-футов}

ПРИМЕЧАНИЕ:

Be careful that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and generator when installing the generator.

Connect the generator wire with the nut and bolt.

Момент затяжки:

9.8 Н*м{100 кгс*см, 87 фунт-сила-дюймов}for nut

7.7 Н*м{79 кгс*см, 68 фунт-сила-дюймов}for bolt

Install the terminal cap.

Connect the generator connector.

Install the front drive shaft (see page RAV4_ACA30 RM00000226O000X.html).

Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.

Специальный инструмент (SST):

09216-42010

ПРИМЕЧАНИЕ:

1. Make sure that the V-ribbed belt is set properly at each pulley.
   
2. Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.
   

Install the reinforcement with the 4 bolts.

Момент затяжки:

95 Н*м{969 кгс*см, 70 фунт-сила-футов}

Install the engine under cover with the 2 clips.

Install the engine under cover with the 12 clips and 4 bolts.

Attach the 4 clips to install the engine cover.