Land Cruiser Prado GRJ150 TRJ150 TRJ155 KDJ150 TRJ155 LJ150 - МЕХАНИЧЕСКАЯ ЧАСТЬ ДВИГАТЕЛЯ 5L-E
REMOVE MANUAL TRANSMISSION ASSEMBLY
REMOVE CLUTCH COVER ASSEMBLY
REMOVE CLUTCH DISC ASSEMBLY
REMOVE FLYWHEEL SUB-ASSEMBLY
REMOVE REAR END PLATE
REMOVE FLYWHEEL HOUSING DUST SEAL
REMOVE REAR CRANKSHAFT OIL SEAL
ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА - СНЯТИЕ
| 1. REMOVE MANUAL TRANSMISSION ASSEMBLY |
Remove the manual transmission (See page ).
| 2. REMOVE CLUTCH COVER ASSEMBLY |
Place matchmarks on the clutch cover and flywheel.
| *a | Matchmark |
Loosen each set bolt one turn at a time until spring tension is released.
Remove the 6 set bolts and pull off the clutch cover.
- ПРИМЕЧАНИЕ:
- Do not drop the clutch disc.
| 3. REMOVE CLUTCH DISC ASSEMBLY |
- ПРИМЕЧАНИЕ:
- Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.
| 4. REMOVE FLYWHEEL SUB-ASSEMBLY |
Using SST, hold the crankshaft.
- SST
- 09213-54015(91651-60855)
09330-00021
Remove the 8 bolts and flywheel.
| 5. REMOVE REAR END PLATE |
Remove the 2 bolts and rear end plate.
| 6. REMOVE FLYWHEEL HOUSING DUST SEAL |
| 7. REMOVE REAR CRANKSHAFT OIL SEAL |
Using a knife, cut off the lip of the oil seal.
| *a | Cut Position |
Using a screwdriver, pry out the oil seal.
- ПРИМЕЧАНИЕ:
- After the removal, check that the crankshaft is not damaged. If damaged, repair it with a sandpaper (#400).
- УКАЗАНИЕ:
- Tape the screwdriver before use.