Loosen the hose clamp and remove the 2 bolts and intake pipe.

Remove the bolt and disconnect the PCV hose and heater hose bracket.

Disconnect the manifold absolute pressure sensor connector.

Remove the 3 nuts, intake flange and gasket.

Disconnect the throttle open switch connector.

Remove the 2 bolts and disconnect the wire harness bracket.

Disconnect the throttle control motor connector.

Remove the diesel throttle body and gasket.

Using a 17 mm union nut wrench, loosen the 8 union nuts of the 4 injection pipes.

Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes together with the 2 lower pipe clamps.

Remove the bolt and disconnect the wire harness bracket.

Remove the 6 bolts, 2 nuts, intake manifold and gasket.