Land Cruiser Prado GRJ150 TRJ150 TRJ155 KDJ150 TRJ155 LJ150 - МЕХАНИЧЕСКАЯ ЧАСТЬ ДВИГАТЕЛЯ 5L-E
REPLACE TIGHT PLUG
REPLACE STRAIGHT PIN
REPLACE RING PIN
REPLACE CONNECTING ROD SMALL END BUSH
БЛОК ЦИЛИНДРОВ - ЗАМЕНА
| 1. REPLACE TIGHT PLUG |
- ПРИМЕЧАНИЕ:
- If coolant leaks from the tight plug or the plug is corroded, replace it.
| *a | Right Side | *b | Rear Side |
| *c | Left Side | *d | Stops |
Apply adhesive to new tight plugs.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the tight plugs as shown in the illustration.
Using SST, tap in the 2 tight plugs labeled A.
- SST
- 09950-60010(09951-00250)
09950-70010(09951-07100)
Using SST, tap in the 4 tight plugs labeled B.
- SST
- 09950-60010(09951-00350)
09950-70010(09951-07100)
Using SST, tap in the tight plug labeled C.
- SST
- 09950-60010(09951-00500)
09950-70010(09951-07100)
| 2. REPLACE STRAIGHT PIN |
- ПРИМЕЧАНИЕ:
- It is not necessary to remove a straight pin unless it is being replaced.
Install the straight pins as shown in the illustration.
| *a | Rear Side | *b | Until Pin Stops |
| 3. REPLACE RING PIN |
- ПРИМЕЧАНИЕ:
- It is not necessary to remove a ring pin unless it is being replaced.
Install the ring pins as shown in the illustration.
| *a | Front Side | *b | Cylinder Head Side |
| *c | Rear Side | *d | Until Pin Stops |
| 4. REPLACE CONNECTING ROD SMALL END BUSH |
Using SST and a press, press out the bushing.
- SST
- 09222-54011(09222-03016,09222-03026,09222-03021)
Using a round file, lightly file off any roughness from the small end of the connecting rod.
Attach a new bush to SST with the ball of SST inside the oil hole of the bush.
- SST
- 09222-54011(09222-03021)
| *1 | Oil Hole |
| *2 | Ball |
Align the oil holes of the bush and connecting rod.
| *1 | Oil Hole |
Using SST and a press, press in the bush.
- SST
- 09222-54011(09222-03016,09222-03026,09222-03021)
| *1 | Bush |
Using a pin hole grinder, hone the bush to obtain the clearance between the bush and piston pin.
Check the piston pin fit at normal room temperature.
Coat the piston pin with engine oil, and push it into the connecting rod with your thumb.