METER / GAUGE SYSTEM - Odo/Trip Switch Malfunction

DESCRIPTION

w/ Multi-information Display:

The ODO/TRIP display of the meter changes each time the ODO/TRIP switch on the light control rheostat is pressed.

For more information about changing between displays, refer to the owner's manual.

Meter / Gauge System - Odo/Trip Switch Malfunction. METER / GAUGE / DISPLAY. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

1.READ VALUE USING INTELLIGENT TESTER (LIGHT CONTROL RHEOSTAT)

Operate the intelligent tester according to the display and select Data List.

Combination Meter
Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
ODO/TRIP Change SW	Trip switch (ODO/TRIP switch) condition/ON or OFF	ON: Trip switch pushed OFF: Trip switch not pushed	-

REPLACE COMBINATION METER ASSEMBLY ()

2.INSPECT LIGHT CONTROL RHEOSTAT (TRIP SWITCH)

Remove the light control rheostat ().

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (A/B) - 1 (E) TRIP switch ON (Pushed) Below 200 Ω
TRIP switch OFF (Not pushed) 1 MΩ or higher

REPLACE LIGHT CONTROL RHEOSTAT ()

OK

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - LIGHT CONTROL RHEOSTAT AND BODY GROUND)

Disconnect the E8 ECU connector.

Disconnect the E9 switch connector.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E8-4 (RSET) - E9-4 (A/B) Always Below 1 Ω
E8-23 (E2) - E9-1 (E)
E8-23 (E2) - Body ground
E8-4 (RSET) or E9-4 (A/B) - Body ground 10 kΩ or higher

REPAIR OR REPLACE HARNESS OR CONNECTOR

REPLACE COMBINATION METER ASSEMBLY ()