Body Electrical. Lexus Is250, Is220D. Gse20 Ale20
Meter. Lexus Is250, Is220D. Gse20 Ale20
Steering Pad Switch -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).
| 2. REMOVE NO. 3 LOWER STEERING WHEEL COVER |
Using a screwdriver, remove the steering wheel No.3 cover lower.
- HINT:
- Tape up the screwdriver tip before use.
 |
| 3. REMOVE NO. 2 LOWER STEERING WHEEL COVER |
Using a screwdriver, remove the steering wheel No.2 cover lower.
- HINT:
- Tape up the screwdriver tip before use.
 |
| 4. REMOVE STEERING PAD |
Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.
 |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
 |
Disconnect the horn connector.
Disconnect the 2 connectors from the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the steering pad.
| 5. REMOVE STEERING PAD SWITCH ASSEMBLY |
Disconnect the 2 connectors and disengage the clamp.
 |
Remove the 2 screws.
 |
Disengage the 4 pins and remove the steering pad switch assembly.