Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV STARTING
GLOW PLUG - REMOVAL
- NOTICE:
When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.
w/DPF
When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.
When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 3. REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler) |
()
| 4. REMOVE INJECTION PIPES |
()
| 5. REMOVE NO. 1 GLOW PLUG CONNECTOR |
Remove the 2 screw grommets and 2 nuts, and disconnect the 2 wire harnesses.
Remove the 8 screw grommets, 8 nuts and 2 glow plug connectors.
| *a | RH |
| *b | LH |
| 6. REMOVE GLOW PLUG ASSEMBLY |
Using a 10 mm deep socket wrench, remove the 8 glow plugs.
| *a | RH |
| *b | LH |
- HINT:
- Before removing the glow plugs, thoroughly clean off all dirt, sand, etc.