Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE STARTING
ENGINE SWITCH - INSPECTION
| 1. INSPECT ENGINE SWITCH |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Switch Condition Specified Condition 7 (SS1) - 5 (GND)
2 (SS2) - 5 (GND)Not pushed 10 kΩ or higher 7 (SS1) - 5 (GND)
2 (SS2) - 5 (GND)Pushed Below 1 Ω
| *a | Component without harness connected (Engine Switch) |
If the result is not as specified, replace the engine switch.
Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
- HINT:
If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
If the voltage is too low, the indicator will not illuminate.
- OK:
Measurement Condition Specified Condition Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 5 (GND)Illuminates (illumination of lettering) Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 5 (GND)Illuminates (green) Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 5 (GND)Illuminates (amber)
| *1 | Indicator | - | - |
| *a | Component without harness connected (Engine Switch) | - | - |
If the result is not as specified, replace the engine switch.