Rear Airbag Sensor Removal
PRECAUTION
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE REAR SEAT CUSHION ASSEMBLY
REMOVE REAR SEAT HEADREST ASSEMBLY
REMOVE REAR SEAT CENTER HEADREST ASSEMBLY
REMOVE REAR SEATBACK ASSEMBLY
REMOVE REAR DOOR SCUFF PLATE
REMOVE REAR SEAT SIDE GARNISH
REMOVE REAR AIRBAG SENSOR
Rear Airbag Sensor -- Removal |
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- CAUTION:
- Be sure to read "PRECAUTION" thoroughly before servicing (Click here).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
3. REMOVE REAR SEAT CUSHION ASSEMBLY |
Detach the 2 front hooks of the seat cushion from the vehicle body.
- NOTICE:
- Follow the instructions below carefully as the cushion frame deforms easily.
Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.
Repeat for the other hook.
Detach the 2 rear hooks of the seat cushion from the seatback.
Remove the seat cushion.
4. REMOVE REAR SEAT HEADREST ASSEMBLY |
5. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY |
6. REMOVE REAR SEATBACK ASSEMBLY |
Using a screwdriver, detach the claws to open the cap of the 3 rear seat shoulder belt guides.
Using a screwdriver, detach the claw to open the cap of the 3 rear seat shoulder belt guides.
Remove the 4 bolts and rear seatback assembly.
7. REMOVE REAR DOOR SCUFF PLATE |
Put protective tape around the rear door scuff plate.
Using a moulding remover, disengage the 2 clips.
Disengage the 5 claws and remove the the rear door scuff plate LH.
8. REMOVE REAR SEAT SIDE GARNISH |
Disengage the 5 claws and remove the rear seat side garnish LH.
9. REMOVE REAR AIRBAG SENSOR |
Disconnect the connector.
Remove the bolt and rear airbag sensor.