Dtc 047 Short In Heater Fuel Pump Circuit
Heater. Lexus Is250, Is220D. Gse20 Ale20
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (COMBUSTION HEATER ASSEMBLY - HEATER FUEL PUMP)
CHECK HARNESS AND CONNECTOR (HEATER FUEL PUMP - BODY GROUND)
INSPECT HEATER FUEL PUMP
DTC 047 Short in Heater Fuel Pump Circuit |
DTC 048 Heater Fuel Pump Malfunction |
DTC 049 Heater Fuel Pump Output Error |
DESCRIPTION
DTC No.
| DTC Detection Condition
| Trouble Area
|
047
| A short is detected in the heater fuel pump circuit.
| - Wire harness or connector between heater fuel pump and combustion heater assembly
- Wire harness or connector between heater fuel pump and body ground
- Heater fuel pump
- Combustion heater assembly
|
048
| Operation stop of the heater fuel pump is detected. (Open in the circuit)
| - Wire harness or connector between combustion heater assembly and heater fuel pump
- Wire harness or connector between heater fuel pump and body ground
- Heater fuel pump
- Combustion heater assembly
|
049
| An error is detected in output to the heater fuel pump.
| - Wire harness or connector between combustion heater assembly and heater fuel pump
- Wire harness or connector between heater fuel pump and body ground
- Heater fuel pump
- Power heater ECU (combustion heater assembly)
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK HARNESS AND CONNECTOR (COMBUSTION HEATER ASSEMBLY - HEATER FUEL PUMP) |
Disconnect the connector from the combustion heater assembly.
Disconnect the connector from the heater fuel pump.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester connection (Symbols)
| Condition
| Specified condition
|
A51-2 (L) - Q55-2
| Always
| Below 1 Ω
|
A51-2 (L) - Body ground
| Always
| 10 kΩ or higher
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
2.CHECK HARNESS AND CONNECTOR (HEATER FUEL PUMP - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester connection (Symbols)
| Condition
| Specified condition
|
Q55-1 - Body ground
| Always
| Below 1 Ω
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
3.INSPECT HEATER FUEL PUMP |
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester connection
| Condition
| Specified condition
|
Q55-2 - Q55-1
| Always
| 9 to 12 Ω
|
Inspect heater fuel pump operation.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, and check the pressure of the hose by hand.
- NOTICE:
- This inspection must be done quickly (within 10 seconds) to prevent damage to the heater fuel pump.
- OK:
- The pressure is applied to the hose.
OK |
|
|
|
REPLACE COMBUSTION HEATER ASSEMBLY |
|