Front Speed Sensor Installation

Wipe off sealant attached to the front speed sensor's fitting surface with white gasoline.

NOTICE:

Prevent foreign matter from attaching to the sensor rotor.

Install a new front speed sensor to the hub and bearing assembly. The front speed sensor connector should be placed in the upper position.

Using the SST and press, install the skid control sensor onto the hub and bearing.

SST

09214-76011

NOTICE:

1. Keep the sensor away from magnets.
   
2. Do not use a hammer on the front speed sensor.
   
3. Check that there is no foreign matter such as iron chips on the front speed sensor's detecting portion.
   
4. Slowly press the front speed sensor straight.
   

Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.

Torque:

69 N*m{702 kgf*cm, 51 ft.*lbf}

Using a dial indicator, check for looseness near the center of the axle hub.

Maximum:

0.05 mm (0.0020 in.)

NOTICE:

Ensure that the dial indicator is perpendicular to the measurement surface.

Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

Maximum:

0.05 mm (0.0020 in.)

NOTICE:

Ensure that the dial indicator is set perpendicular to the measurement surface.

Align the matchmarks and install the front disc.

HINT:

When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.

Install the brake caliper assembly and new No. 1 caliper plates to the steering knuckle with the 2 bolts.

Torque:

78 N*m{795 kgf*cm, 58 ft.*lbf}

NOTICE:

1. Do not twist the front brake hose when installing the front disc brake caliper.
   
2. Make sure that there are no foreign objects or damage to the threads of the bolts.
   
3. Do not overtighten the bolts because the steering knuckle is made of aluminum and may be damaged easily.
   

Connect the speed sensor connector to the front speed sensor.

NOTICE:

Do not twist the sensor wire.