Vehicle Stability Control System (W/ Vdim) Brake Warning Light Does Not Come On
Brake. Lexus Is250, Is220D. Gse20 Ale20
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK CAN COMMUNICATION SYSTEM
CHECK MULTIPLEX COMMUNICATION SYSTEM
CHECK BRAKE WARNING LIGHT
INSPECT COMBINATION METER ASSEMBLY
VEHICLE STABILITY CONTROL SYSTEM (w/ VDIM) - Brake Warning Light does not Come ON |
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN and multiplex communications.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid control ECU, perform zero point calibration and store system information (Click here).
1.CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (Click here for LHD, or Click here for RHD).
- Result:
Condition
| Proceed to
|
DTC is not output
| A
|
DTC is output
| B
|
| INSPECT CAN COMMUNICATION SYSTEM |
|
|
2.CHECK MULTIPLEX COMMUNICATION SYSTEM |
Check if the multiplex communication system DTC is output (Click here).
- Result:
Condition
| Proceed to
|
DTC is not output
| A
|
DTC is output
| B
|
| INSPECT MULTIPLEX COMMUNICATION SYSTEM |
|
|
3.CHECK BRAKE WARNING LIGHT |
Disconnect the skid control ECU connector.
Turn the engine switch on (IG).
Check that the BRAKE warning light comes on.
- OK:
- BRAKE warning light comes on.
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).
4.INSPECT COMBINATION METER ASSEMBLY |
Turn the engine switch off.
Reconnect the skid control ECU connector.
Perform Active Test of the combination meter (meter CPU) using the intelligent tester (Click here).
- OK:
- The BRAKE warning light turns on or off in accordance with the intelligent tester.
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
| REPLACE COMBINATION METER ASSEMBLY |
|
|