Dtc C1203/59 Ecm Communication Circuit Malfunction

Brake. Lexus Is250, Is220D. Gse20 Ale20
Brake Control. Lexus Is250, Is220D. Gse20 Ale20

DESCRIPTION

INSPECTION PROCEDURE

CHECK PART NUMBER (ECM)

CLEAR AND STORE SYSTEM INFORMATION

RECONFIRM DTC

DTC C1203/59 ECM Communication Circuit Malfunction

DTC C1270/88 Initialization Incomplete (Test Mode DTC)


DESCRIPTION

  1. The circuit is used to send TRC and VSC control information from the skid control ECU to the ECM, and engine control information from the ECM to the skid control ECU.
  2. If the skid control ECU is replaced or if the memory is cleared, the system information such as the destination or vehicle type will be unconfirmed. After switching to the Test Mode, the skid control ECU performs initialization when starting communication with the vehicle, and stores the system information in 2 or 3 seconds. DTC C1270/88 can be cleared when the initialization is completed normally or the Test Mode ends. DTC C1270/88 is output only in the Test Mode.

DTC No.
DTC Detection Condition
Trouble Area
C1203/59
Engine, drive source and destination variations that are sent from the ECM do not match the ones of the skid control ECU or there is no information in the memory.
ECM

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform zero point calibration and store system information (Click here).
1.CHECK PART NUMBER (ECM)
  1. Check that the part number of the installed ECM is correct.

    OK:
    ECM installed in the vehicle has correct part number.


NG
REPLACE ECM
OK


2.CLEAR AND STORE SYSTEM INFORMATION
  1. Clear the system information (Click here).

  1. Store the system information (Click here).


NEXT


3.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:

    Condition
    Proceed to
    DTC (C1203/59) is not output
    A
    DTC (C1203/59) is output
    B


B
REPLACE SKID CONTROL ECU
A

USE SIMULATION METHOD TO CHECK