Oil Pressure Sensor - Installation

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE LUBRICATION

OIL PRESSURE SENSOR - INSTALLATION

1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

  • Adhesive:
  • Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
  • NOTICE:
Oil Pressure Sensor - Installation. 1UR-FE LUBRICATION. Land Cruiser URJ200 URJ202 GRJ200 VDJ200
  • Do not apply adhesive to the oil inlet port of the oil pressure sender gauge.
Text in Illustration
*1Oil Inlet Port

Install the oil pressure sender gauge.

  • Torque:
  • 15 N*m{ 153 kgf*cm, 11 ft.*lbf}
  • NOTICE:
  • Do not start the engine within 1 hour after installation.

Connect the oil pressure sender gauge connector.

2. INSPECT ENGINE OIL LEVEL

Warm up the engine. Then stop the engine and wait for 5 minutes.

Oil Pressure Sensor - Installation. 1UR-FE LUBRICATION. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Check that the engine oil level is between the dipstick low level mark and full level mark.

Text in Illustration
*aMeasuring Surface
*bLow Level Mark
*cFull Level Mark

If the level is low, check for leakage and add oil up to the full level mark.

  • NOTICE:
  • Do not fill engine oil above the full level mark.
  • HINT:
  • A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.
If low quality oil or oil of an inappropriate viscosity is used.
When driving at high engine speed or with a heavy load, (when towing, or), when driving while accelerating or decelerating frequently.
When leaving the idling for a long time, or when driving frequently through heavy traffic.
  • When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.
3. INSPECT FOR OIL LEAK

Start the engine. Make sure that there are no oil leaks from the area that was worked on.

4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Install the No. 1 engine under cover sub-assembly with the 10 bolts.

  • Torque:
  • 29 N*m{ 296 kgf*cm, 21 ft.*lbf}
5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Push in the clip to install the front fender splash shield sub-assembly RH.

Install the 3 bolts and 2 screws.

6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Push in the clip to install the front fender splash shield sub-assembly LH.

Install the 3 bolts and screw.