Dtc B1247 Tire Pressure Monitor Receiver Communication Stop
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - BATTERY AND BODY GROUND)
CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - BODY GROUND)
CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - COMBINATION METER)
CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - GATEWAY ECU)
DTC B1247 Tire Pressure Monitor Receiver Communication Stop |
DESCRIPTION
This DTC is detected when the communication between the tire pressure warning ECU and gateway ECU stops for more than 10 seconds.DTC No.
| DTC Detection Condition
| Trouble Area
|
B1247
| Tire pressure warning ECU receiver communication stops
| - Tire pressure warning ECU
- Wire harness
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - BATTERY AND BODY GROUND) |
Disconnect the L45 ECU connector.
Turn the engine switch on (IG).
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
| Condition
| Specified Condition
|
L45-1 (IG) - Body ground
| Engine switch on (IG)
| 10 to 14 V
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
2.CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - BODY GROUND) |
Disconnect the L45 ECU connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
| Specified Condition
|
L45-7 (GND) - Body ground
| Below 1 Ω
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
3.CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - COMBINATION METER) |
Disconnect the L45 ECU connector.
Disconnect the L31 combination meter connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
| Specified Condition
|
L45-6 (MPX1) - L31-5 (MPX-)
| Below 1 Ω
|
L45-7 (GND)- Body ground
| 10 kΩ or higher
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
4.CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - GATEWAY ECU) |
Disconnect the L45 ECU connector.
Disconnect the L66 gateway ECU connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
| Specified Condition
|
L45-12 (MPX2) - L66-4 (MPI1)
| Below 1 Ω
|
L45-12 (MPX2 )- Body ground
| 10 kΩ or higher
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
OK |
|
|
|
REPLACE TIRE PRESSURE WARNING ECU |
|