Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV INTAKE / EXHAUST
EXHAUST PIPE (w/ DPF) - REMOVAL
- CAUTION:
| 1. REMOVE AIR FUEL RATIO SENSOR |
()
| 2. REMOVE FRONT FENDER APRON SEAL REAR RH |
Remove the 4 clips and front fender apron seal rear RH.
| 3. REMOVE FRONT FENDER APRON SEAL REAR LH |
Remove the 4 clips and front fender apron seal rear LH.
| 4. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 6 bolts and No. 2 engine under cover.
| 5. REMOVE TAILPIPE ASSEMBLY |
Remove the bolt, clamp and gasket.
Disconnect the tailpipe from the 2 exhaust pipe supports.
| 6. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
Remove the 4 bolts and 2 compression springs.
Disconnect the center exhaust pipe from the 3 exhaust pipe supports.
Remove the gasket from the No. 5 exhaust pipe and front exhaust pipe.
| 7. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the 2 air hoses.
Disconnect the exhaust gas temperature sensor connector and detach the clamp.
Remove the 3 nuts and front exhaust pipe.
Remove the gasket.
| 8. REMOVE NO. 5 EXHAUST PIPE ASSEMBLY |
Remove the 2 nuts and No. 5 exhaust pipe.
Remove the gasket.
| 9. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Disconnect the 2 air hoses.
Disconnect the exhaust gas temperature sensor connector and detach the clamp.
Remove the 3 nuts and front No. 2 exhaust pipe.
Remove the gasket.
| 10. REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR |
- NOTICE:
- If the sensor is dropped, replace it with a new one.
| *A | for Bank 1 |
| *B | for Bank 2 |
Using a 14 mm union nut wrench, remove the 2 No. 4 exhaust gas temperature sensors.
| 11. REMOVE MONOLITHIC CONVERTER ASSEMBLY RH |
Disconnect the 2 exhaust gas temperature sensor connectors and detach the 4 clamps.
Remove the 3 bolts and manifold stay.
Remove the 3 nuts and monolithic converter RH.
Remove the gasket from the turbocharger.
| 12. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
()
| 13. REMOVE MONOLITHIC CONVERTER ASSEMBLY LH |
Disconnect the 2 exhaust gas temperature sensor connectors and detach the 4 clamps.
Remove the 3 bolts and No. 2 manifold stay.
Remove the 3 nuts and monolithic converter LH.
Remove the gasket from the turbocharger.
| 14. REMOVE NO. 3 EXHAUST GAS TEMPERATURE SENSOR |
- NOTICE:
- If the sensor is dropped, replace it with a new one.
Using a 14 mm union nut wrench, remove the No. 3 exhaust gas temperature sensor.
| 15. REMOVE NO. 2 EXHAUST GAS TEMPERATURE SENSOR |
- NOTICE:
- If the sensor is dropped, replace it with a new one.
Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor.
| 16. REMOVE EXHAUST GAS TEMPERATURE SENSOR |
- NOTICE:
- If the sensor is dropped, replace it with a new one.
| *A | for Bank 1 |
| *B | for Bank 2 |
Using a 14 mm union nut wrench, remove the 2 exhaust gas temperature sensors.