Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 3UR-FE INTAKE / EXHAUST
INTAKE SYSTEM - ON-VEHICLE INSPECTION
| 1. INSPECT INTAKE AIR CONTROL VALVE |
Remove the V-bank cover.
Start the engine.
Check that the VSV (for ACIS) is ON (seal) under both of the following conditions:
- NOTICE:
- Do not increase the engine speed to 5400 rpm or more.
Check that the VSV (for ACIS) is OFF (vent) under the following conditions:
| *a | ON (Seal) |
| *b | OFF (Vent) |
Connect the intelligent tester to the DLC3.
Perform the Active Test, and then check that the actuator rod operates.
If the result is not as specified, inspect the intake air control valve, vacuum tank and VSV (for ACIS) for normal operation. Replace malfunctioning parts as necessary.
Install the V-bank cover.
| 2. CHECK INTAKE AIR CONTROL VALVE OPERATION |
Remove the V-bank cover.
Using a 3-way connector, connect a vacuum gauge to the actuator hose.
| *1 | Vacuum Gauge |
Start the engine.
While the engine is idling, check that the vacuum gauge indicates 0 kPa (0 mmHg, 0 in.Hg) and the rod is at the OFF position
Fully depress the accelerator pedal quickly. Check that the VSV (for ACIS) turns ON and the rod moves in the ON direction.
- NOTICE:
- Make sure to fully depress and release the accelerator pedal within 1 second.
Remove the vacuum gauge, and connect the vacuum hose to the actuator.
Install the V-bank cover.
| 3. INSPECT INTAKE AIR CONTROL VALVE |
Inspect the diaphragm.
Using a vacuum pump, apply a vacuum of 27 kPa (200 mmHg, 7.85 in.Hg). Check that the lever moves.
| *1 | Vacuum Pump |
If the result is not as specified, replace the intake air surge tank.
| 4. CHECK AIR INDUCTION SYSTEM |
- HINT:
- The illustration shows the areas that may draw in secondary air, which could lead to idling problems.
Check that the hoses are installed correctly.
Check for cracks, etc. in the hoses.
| *1 | Air Cleaner | *2 | Mass Air Flow Meter |
| *3 | Air Cleaner Hose | *4 | Resonator |
| *5 | Throttle Body | *6 | Fuel Pressure Regulator |
| *7 | Ventilation Pipe | *8 | Intake Manifold |
| *9 | Intake Air Control Valve Actuator (for ACIS) | *10 | Purge VSV |
| *11 | Vacuum Switching Valve (for ACIS) | *12 | Ventilation Pipe |