Cruise Control System Diagnosis System
DESCRIPTION
CHECK DLC3
CHECK INDICATOR
Cruise Control System -- Diagnosis System |
The ECU controls the cruise control system of the vehicle. The data and DTCs relating to the cruise control system can be read through the DLC3 of the vehicle. If either DTC or CRUISE OK is not displayed in the multi-information display on the combination meter when checking for DTCs, there may be a problem with the combination meter or the CAN communication and multiplex communication system. Use the intelligent tester to check and solve the problem.
|
The vehicle's ECM uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15031-03 and matches the ISO 15765-4 format.
Symbols (Terminal No.)
| Terminal Description
| Condition
| Specified Condition
|
SIL (7) - SG (5)
| Bus "+" line
| During transmission
| Pulse generation
|
CG (4) - Body ground
| Chassis ground
| Always
| Below 1 Ω
|
SG (5) - Body ground
| Signal ground
| Always
| Below 1 Ω
|
BAT (16) - Body ground
| Battery positive
| Always
| 11 to 14 V
|
CANH (6) - CANL (14)
| HIGH-level CAN bus line
| Engine switch off
| 54 to 67 Ω
|
CANH (6) - Battery positive
| HIGH-level CAN bus line
| Engine switch off
| 1 MΩ or higher
|
CANH (6) - CG (4)
| HIGH-level CAN bus line
| Engine switch off
| 3 kΩ or higher
|
CANL (14) - Battery positive
| LOW-level CAN bus line
| Engine switch off
| 1 MΩ or higher
|
CANL (14) - CG (4)
| LOW-level CAN bus line
| Engine switch off
| 3 kΩ or higher
|
- HINT:
- Connect the cable of the intelligent tester to the DLC3, turn the engine switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
- If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.
- If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.
Turn the engine switch on (IG).
Check that the CRUISE main indicator light illuminates when the cruise control main switch is turned ON, and that the indicator light turns off when the main switch is turned OFF. If the results are not as specified, inspect the CRUISE main indicator light circuit (Click here).
- HINT:
- While driving with cruise control, the ECM activates AUTO CANCEL of the cruise control system when a malfunction in one of the following occurs: vehicle speed sensors, stop light switch or other related parts. When AUTO CANCEL is activated, the CRUISE main indicator light outputs the blinking pattern shown to the left. At the same time, data of the malfunction is stored as a DTC.
