Rear Differential Side Gear Shaft Oil Seal (For 3Uz-Fe) Replacement

Using a hexagon wrench (10 mm), remove the filler plug and gasket.

Using a hexagon wrench (10 mm), remove the drain plug and gasket, and drain the oil.

Install the differential drain plug and a new gasket.

Torque:

49 N*m{500 kgf*cm, 36 ft.*lbf}

Using SST, remove the oil seal.

SST

09308-10010

Using SST and hammer, install a new oil seal.

SST

09950-70010(09951-07150)
09223-15030

Oil seal drive in depth:

-0.5 to 0.5 mm (-0.020 to 0.020 in.)

Apply MP grease to the oil seal lip.

Using a hexagon wrench (10 mm), remove the differential filler plug and gasket.

Add oil.

Capacity:

1.30 to 1.40 liter (1.38 to 1.48 US qts, 1.15 to 1.23 lmp. qts)

Oil grade:

Differential synthetic gear oil GL-5 75W-90 or equivalent

Check the oil level.

Using a hexagon wrench (10 mm), install the differential filler filler plug with a new gasket.

Torque:

49 N*m{500 kgf*cm, 36 ft.*lbf}

NOTICE:

After replacing the oil, recheck the oil level after driving.

Stop the vehicle on a level place.

Using a hexagon wrench (10 mm), remove the differential filler plug and gasket.

Check that the oil surface is within 5 mm (0.20 in.) of the lowest position of the inner surface of the differential filler plug opening.

NOTICE:

1. Excessively large or small amounts of oil may cause trouble.
   
2. After replacing oil, drive the vehicle and check the oil level.
   

HINT:

If necessary, fill the rear differential carrier with differential synthetic gear oil.

Check for oil leakage when the oil level is low.

Using a hexagon wrench (10 mm), install the differential filler plug and a new gasket.

Torque:

49 N*m{500 kgf*cm, 36 ft.*lbf}