Rear Differential Side Gear Shaft Oil Seal (For 3Gr-Fe) Replacement

Using a hexagon wrench (10 mm), remove the differential filler plug and gasket.

Using a hexagon wrench (10 mm), remove the differential drain plug and gasket, and drain the oil.

Install the differential drain plug and a new gasket.

Torque:

49 N*m{500 kgf*cm, 36 ft.*lbf}

Using SST, remove the oil seal.

SST

09308-00010

Using SST and a hammer, install a new oil seal.

SST

09554-22010

Oil seal drive in depth:

-0.5 to 0.5 mm (-0.020 to 0.020 in.)

Apply MP grease to the oil seal lip.

Using a hexagon wrench (10 mm), remove the differential filler plug and gasket.

Add oil.

Capacity:

1.10 to 1.20 liter (1.17 to 1.27 US qts, 0.97 to 1.05 lmp. qts)

Oil grade:

GENERAL:

Hypoid gear oil API GL-5 or equivalent

Recommended oil viscosity:

Above -18°C (0°F)	SAE 90
Below -18°C (0°F)	SAE 80W or 80W-90

GCC COUNTRIES AND EUROPE:

Toyota genuine differential synthetic gear oil API GL-5 SAE 75W-90 or its equivalent

Check the oil level.

Using a hexagon wrench (10 mm), install the differential filler filler plug with a new gasket.

Torque:

49 N*m{500 kgf*cm, 36 ft.*lbf}

NOTICE:

After replacing the oil, recheck the oil level after driving.

Stop the vehicle on a level place.

Using a hexagon wrench (10 mm), remove the differential filler plug and gasket.

Check that the oil surface is within 5 mm (0.20 in.) of the lowest position of the inner surface of the differential filler plug opening.

NOTICE:

1. Excessively large or small amounts of oil may cause trouble.
   
2. After replacing oil, drive the vehicle and check the oil level.
   

HINT:

If necessary, fill the rear differential carrier with gear oil.

Check for oil leakage when the oil level is low.

Using a hexagon wrench (10 mm), install the differential filler plug and a new gasket.

Torque:

49 N*m{500 kgf*cm, 36 ft.*lbf}