Engine. Lexus Gs430, Gs300. Uzs190 Grs190
3Uz-Fe Emission Control. Lexus Gs430, Gs300. Uzs190 Grs190
Heated Oxygen Sensor (For Sensor 2) -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH |
 |
Using a clip remover, detach the claws and remove the garnish.
- HINT:
- Tape the clip remover tip before use.
| 3. REMOVE FRONT ASH RECEPTACLE ASSEMBLY |
 |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
Using a screwdriver, detach the 9 clips.
- HINT:
- Tape the screwdriver tip before use.
 |
Remove the ash receptacle and then disconnect the connector.
| 4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
 |
Remove the screw.
Using a screwdriver, detach the 3 clips and 3 claws.
- HINT:
- Tape the screwdriver tip before use.
Remove the finish panel end.
| 5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
 |
Remove the screw.
Using a screwdriver, detach the 4 clips and 3 claws.
- HINT:
- Tape the screwdriver tip before use.
Remove the finish panel end.
| 6. REMOVE HEATED OXYGEN SENSOR (for Bank 1) |
Disconnect the sensor connector.
 |
Disconnect the grommet and pull the sensor connector out of the cabin through the floor panel.
Using SST, remove the sensor.
- SST
- 09224-00010
 |
| 7. REMOVE HEATED OXYGEN SENSOR (for Bank 2) |
Disconnect the sensor connector.
 |
Disconnect the grommet and pull the sensor connector out of the cabin through the floor panel.
Using SST, remove the sensor.
- SST
- 09224-00010
 |