Heated Oxygen Sensor (For Sensor 2) Removal
Engine. Lexus Gs430, Gs300. Uzs190 Grs190
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT CONSOLE UPPER GARNISH
REMOVE CONSOLE UPPER PANEL ASSEMBLY
REMOVE CONSOLE BOX PLATE
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
Heated Oxygen Sensor (For Sensor 2) -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE FRONT CONSOLE UPPER GARNISH |
Using a clip remover, detach the claws and remove the garnish.
- HINT:
- Tape the clip remover tip before use.
| 3. REMOVE CONSOLE UPPER PANEL ASSEMBLY |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
Using a screwdriver, detach the 9 clips.
- HINT:
- Tape the screwdriver tip before use.
Remove the ash receptacle and then disconnect the connector.
| 4. REMOVE CONSOLE BOX PLATE |
Using a screwdriver, detach the 4 clips.
- HINT:
- Tape the screwdriver tip before use.
Remove the console box plate and then disconnect the connector.
| 5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
Remove the screw.
Using a screwdriver, detach the 3 clips and 3 claws.
- HINT:
- Tape the screwdriver tip before use.
Remove the finish panel end.
| 6. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
Remove the screw.
Using a screwdriver, detach the 4 clips and 3 claws.
- HINT:
- Tape the screwdriver tip before use.
Remove the finish panel end.
| 7. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
Disconnect the sensor connector.
Remove the grommet and pass the sensor connector out of the cabin through the floor panel.
Using SST, remove the sensor from the front exhaust pipe.
- SST
- 09224-00010
| 8. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
Disconnect the sensor connector.
Remove the grommet and pass the sensor connector out of the cabin through the floor panel.
Using SST, remove the sensor from the front exhaust pipe.
- SST
- 09224-00010
