Fuel Sender Gauge Assembly (For Fuel Sub Tank) - Installation

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 3UR-FE FUEL

FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) - INSTALLATION

1. INSTALL FUEL SENDER GAUGE ASSEMBLY

Install a new gasket to the sender gauge.

Install the sender gauge with the 5 screws.

  • Torque:
  • 1.5 N*m{ 15 kgf*cm, 13 in.*lbf}
  • NOTICE:
  • Be careful not to bend the arm of the fuel sender gauge.

Connect the sender gauge connector.

2. INSTALL REAR FLOOR SERVICE HOLE COVER

Install the service hole cover with new butyl tape.

3. INSTALL REAR NO. 7 AIR DUCT
Fuel Sender Gauge Assembly (For Fuel Sub Tank) - Installation. 3UR-FE FUEL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Attach the 4 clips to install the air duct.

  • HINT:
  • Attach the clips in the order shown in the illustration.
4. INSTALL REAR FLOOR MAT ASSEMBLY

Attach the 5 clips to install the floor mat.

5. INSTALL REAR NO. 2 SEAT ASSEMBLY

for Face to Face Seat Type:


Install the rear No. 2 seat assembly ().

except Face to Face Seat Type:


Install the rear No. 2 seat assembly ().

6. INSTALL REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

()


7. INSTALL REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

()


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
  • NOTICE:
  • When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().