Crankshaft Position Sensor Installation

Apply a light coat of engine oil to a new O-ring of the sensor.

Install the sensor with the bolt.

Torque:

10 N*m{102 kgf*cm, 7 ft.*lbf}

Connect the sensor connector.

Using an E8 "torx" socket, install the compressor with the stud bolt.

Torque:

10 N*m{102 kgf*cm, 7 ft.*lbf}

Install the compressor with the 3 bolts and nut.

Torque:

24.5 N*m{250 kgf*cm, 18 ft.*lbf}

NOTICE:

Tighten the bolts in the order shown in the illustration to install the compressor.

Install the under cover with the 10 bolts and 3 clips.

Install the V-ribbed belt.

While turning the belt tensioner counterclockwise, remove the bar.

NOTICE:

1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
   
2. Check that the V-ribbed belt is properly set to each pulley.
   

If it is difficult to install the V-ribbed belt, perform the following procedure.

1. Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.
   

2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
   

   NOTICE:

   1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
      
   2. Check that the V-ribbed belt is properly set to each pulley.
      

Install the V-bank cover with the 2 nuts.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Install the air cleaner inlet with the bolt.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Install the side cover with the 3 clips.

Install the side cover with the 2 clips and nut.

Install the intake duct seal with the 7 clips.

Perform initialization (Click here).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.