Rocker Panel Moulding Installation

Vehicle Exterior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Exterior Panels Trim. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY LH

  2. INSTALL SIDE STEP ASSEMBLY LH

  3. INSTALL FRONT FENDER MUDGUARD LH

Rocker Panel Moulding -- Installation


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. When installing the rocker panel moulding, heat the vehicle body and rocker panel moulding using a heat light.
Standard Heating Temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Rocker Panel Moulding
20 to 30°C (68 to 86°F)
NOTICE:
Do not heat the vehicle body and rocker panel moulding excessively.


1. INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY LH

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.



  1. If reusing the rocker panel moulding:
    Clean the rocker panel moulding.

    1. Using a heat light, heat the rocker panel moulding.

    2. Remove the double-sided tape from the rocker panel moulding.

    3. Wipe off any tape adhesive residue with cleaner.



    4. Apply new double-sided tape to the rocker panel moulding, as shown in the illustration.


      Land Cruiser. Urj200, 202 Grj200 Vdj200.Exterior Panels Trim.Front Bumper (For Standard).Rocker Panel Moulding Installation



  1. Install the rocker panel moulding.

    1. Using a heat light, heat the vehicle body and rocker panel moulding.

    2. Remove the peeling paper from the face of the rocker panel moulding.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    3. Attach the 10 clips to install the rocker panel moulding.



    4. Install the 8 side mudguard retainers and screw.


      Land Cruiser. Urj200, 202 Grj200 Vdj200.Exterior Panels Trim.Front Bumper (For Standard).Rocker Panel Moulding Installation



2. INSTALL SIDE STEP ASSEMBLY LH


  1. Install the side step with the 6 bolts.

    Torque:
    30 N*m{306 kgf*cm, 22 ft.*lbf}


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Exterior Panels Trim.Front Bumper (For Standard).Rocker Panel Moulding Installation



3. INSTALL FRONT FENDER MUDGUARD LH


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Attach the guide to install the front fender mudguard LH.

  1. Install the clip.

  1. Using a T30 "TORX" socket, install the 4 screws.