Front Door Belt Moulding Installation

Attach the claw to install the belt moulding.

Install the front door glass run LH.

Temporarily install the multiplex network master switch assembly.

Connect the cable to the negative (-) battery terminal.

Move the front door window regulator sub-assembly LH so that the front door glass sub-assembly LH bolts can be seen.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

1. Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
   
2. If the airbag deploys for any reason, it may cause a serious accident.
   

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

Disconnect the multiplex network master switch assembly.

Insert the front door glass sub-assembly LH into the door panel along the glass run as indicated by the arrows in the illustration.

NOTICE:

Be careful not to damage the glass.

Install the front door glass sub-assembly LH to the front door window regulator sub-assembly LH with the 2 bolts.

Torque:

8.0 N*m{82 kgf*cm, 71 in.*lbf}

Attach the 4 claws to install the front inner door glass weatherstrip LH.

Apply butyl tape to the door.

Pass the front door lock remote control cable assembly LH and front door inside locking cable assembly LH through a new front door service hole cover LH.

NOTICE:

1. When installing the front door service hole cover LH, pull the links and connectors through the front door service hole cover LH.
   
2. There should be no wrinkles or folds after attaching the front door service hole cover LH.
   
3. After attaching the front door service hole cover LH, check the sealing quality.
   

Connect the 2 connectors.

Attach the 9 clamps.

Install the bolt as shown in the illustration.

Torque:

8.4 N*m{86 kgf*cm, 74 in.*lbf}

Attach the claw and Install the mirror with the 3 nuts.

Torque:

8.0 N*m{82 kgf*cm, 71 in.*lbf}

w/ Power Mirror Control System:

1. Attach the clamp.
   

2. Connect the connector labeled A.
   

Connect the connector.

Connect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH to the front door inside handle sub-assembly LH.

Attach the 4 claws and 13 clips to install the front door trim board sub-assembly LH.

Install the 3 screws.

Attach the 8 claws to install the door assist grip cover LH to the front door trim board sub-assembly LH.

Connect the connector.

Attach the 5 claws to install the armrest base panel.

Attach the 4 claws to install the front door inside handle bezel LH.

Attach the clip and claw, and install the front door lower frame bracket garnish LH.