Height Control Sensor Inspection

Vehicle Exterior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Lighting (Ext). Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

Height Control Sensor -- Inspection



1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH



Land Cruiser. Urj200, 202 Grj200 Vdj200.Lighting (Ext).Lighting System.Height Control Sensor Inspection


Text in Illustration
*a
Component without harness connected
(Rear Height Control Sensor Sub-assembly LH)
*b
Low (-)
*c
Normal
*d
High (+)
NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.

  1. Connect 3 dry batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 1 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRL) and terminal 3 (SHG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Condition
    		Specified Condition
    2 (SHRL) - 3 (SHG)
    		High (+)
    		Approx. 4.5 V
    Normal
    		Approx. 2.25 V
    Low (-)
    		Approx. 0.5 V
    NOTICE:
    1. Do not apply a voltage of higher than 6 V.
    2. Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.