Wiper And Washer System (W/ Rain Sensor) Headlight Cleaner Switch Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HEADLIGHT ASSEMBLY (LO BEAM)
INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY
CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY AND MAIN BODY ECU)
WIPER AND WASHER SYSTEM (w/ Rain Sensor) - Headlight Cleaner Switch Circuit |
DESCRIPTION
This circuit detects the conditions of the headlight cleaner switch.- Headlight cleaner switch signal
- Headlight operating signal
- Daytime running light operating signal
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK HEADLIGHT ASSEMBLY (LO BEAM) |
Check that the headlights illuminate in LO beam.
- OK:
- Headlights illuminate in LO beam
| 2.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY |
Disconnect the G4 cleaner switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
8 (B) - 5 (L)
| Headlight cleaner switch off
| 10 kΩ or higher
|
8 (B) - 5 (L)
| Headlight cleaner switch on
| Below 1 Ω
|
| | REPLACE HEADLIGHT CLEANER SWITCH ASSEMBLY (Click here) |
|
|
| 3.CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY AND MAIN BODY ECU) |
Disconnect the headlight cleaner control relay connector.
Disconnect the G4 switch connector.
Disconnect the 2D main body ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
2 (H) - G4-8 (B)
| Always
| Below 1 Ω
|
G4-5 (L) - 2D-23 (HRLY)
|
2 (H) - Body ground
| Always
| 10 kΩ or higher
|
G4-8 (B) - Body ground
|
G4-5 (L) - Body ground
|
2D-23 (HRLY) - Body ground
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
|
|
| REPLACE HEADLIGHT CLEANER CONTROL RELAY (Click here) |
|
