Outer Rear View Mirror Disassembly

Push the upper part of the mirror surface and tilt it.

Using a moulding remover, detach the 4 claws and separate the outer mirror LH from the mirror body.

HINT:

Apply protective tape to the outer rear mirror LH to prevent it from being damaged.

w/ EC Mirror:
Disconnect the connector and remove the outer mirror LH.

w/ Mirror Heater:
Disconnect the 2 connectors and remove the outer mirror LH.

Using 2 screwdrivers, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.

Insert a screwdriver into the slot as shown in the illustration and push on the outer mirror body to create a space between the outer mirror body and outer mirror cover.

NOTICE:

Be careful not to break the ribs.

HINT:

Tape the screwdriver tip before use.

Apply protective tape to the areas of the body cover and outer mirror cover as shown in the illustration.

HINT:

Tape the moulding remover before use.

Insert a moulding remover into the space made between the outer mirror body and outer mirror cover.

NOTICE:

Do not insert the moulding remover more than 4 mm (0.157 in.).

Standard:

Area	Specified Condition
a	4mm

Slide the moulding remover downwards as shown in the illustration to detach the 2 claws.

NOTICE:

1. Do not insert the moulding remover more than 4 mm (0.157 in.).
   
2. Do not slide the moulding remover past the point approximately 40 mm (1.57 in.) from the bottom edge of the outer mirror cover as the outer mirror body will become damaged.
   

Standard:

Area	Specified Condition
a	40mm
b	4mm

Remove the moulding remover B.

Apply protective tape to the areas of the body cover and outer mirror cover as shown in the illustration.

Insert a moulding remover B between the outer mirror cover and outer mirror body as shown in the illustration and detach the claw.

Using a screwdriver, detach the claw.

Detach the 2 claws and remove the outer mirror cover.

NOTICE:

When removing the cover, be careful not to damage the side turn signal light assembly or cover.

Remove the 3 screws and light.

Disconnect the connector.

Remove the gasket

1. Remove the tape.
   





2. Detach the 9 guides and remove the gasket.
   

   HINT:

   Slightly lower the gasket so that the television camera assembly can be removed.

Remove the lower mirror cover

1. Using a screwdriver with its tip wrapped in protective tape, disconnect the 4 claws and remove the lower mirror cover.
   

   Text in Illustration

   *1	Protective Tape

Remove the base

1. Remove the wire harness.
   





2. Using "TORX" socket wrench T25, remove the 3 screws.
   

   NOTICE:

   Make sure to replace the "TORX" screws with new ones.

3. Disconnect the guide and remove the base.
   

Detach the connector from the wire clip.

Using a screwdriver, disconnect the connector.

HINT:

Tape the moulding remover before use.

Remove the body

1. Remove the 5 screws and body.
   

Remove the body

1. Disconnect the 2 guides and remove the body.
   

   NOTICE:

   Be careful not to break the guide shown in the part of the illustration labeled A.

Remove the 3 screws and side television camera.