Front Crankshaft Oil Seal - Installation

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV ENGINE MECHANICAL

FRONT CRANKSHAFT OIL SEAL - INSTALLATION

1. INSTALL FRONT CRANKSHAFT OIL SEAL

Apply engine oil to the lip of a new oil seal.

Front Crankshaft Oil Seal - Installation. 1VD-FTV ENGINE MECHANICAL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Using SST and a hammer, tap in the oil seal as shown in the illustration.

  • SST
  • 09316-12010
    09950-70010(09951-07100)
    09950-60020(09951-00890)
  • Standard depth A:
  • 0.6 to 1.4 mm (0.0236 to 0.0551 in.)
  • NOTICE:
  • Make sure that the lip of the oil seal is properly installed.
2. INSTALL CRANKSHAFT PULLEY SUB-ASSEMBLY
  • NOTICE:
  • This procedure is intended for removal/installation of the crankshaft pulley only. Do not use this procedure for removal/installation of the flywheel or the drive plate and ring gear.
Front Crankshaft Oil Seal - Installation. 1VD-FTV ENGINE MECHANICAL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Align the crankshaft pulley and the crankshaft knock pin, and temporarily install the crankshaft pulley with the 3 bolts.

Text in Illustration
*1Service Hole
*2Protrusion

Install the 2 bolts to the bolt holes of the crankshaft rear side.

Using a bar, turn the crankshaft until the crankshaft pulley service hole is a little to the right of bottom dead center.

Install a 14 mm x 1.5 pitch service bolt with a length of 70 mm or more to the crankshaft pulley service hole, and hold the crankshaft using the timing chain cover protrusion.

Front Crankshaft Oil Seal - Installation. 1VD-FTV ENGINE MECHANICAL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Uniformly tighten the 3 bolts in 2 passes in the order shown in the illustration.

  • Torque:
  • 115 N*m{ 1168 kgf*cm, 84 ft.*lbf}

Remove the service bolt.

3. INSTALL RADIATOR ASSEMBLY

()