REMOVE RADIATOR ASSEMBLY

REMOVE CRANKSHAFT PULLEY SUB-ASSEMBLY

REMOVE FRONT CRANKSHAFT OIL SEAL

Install the 2 bolts to the bolt holes of the crankshaft rear side.

Using a bar, turn the crankshaft until the crankshaft pulley service hole is a little to the left of bottom dead center.

Install a 14 mm x 1.5 pitch service bolt with a length of 70 mm or more to the crankshaft pulley service hole, and hold the crankshaft using the timing chain cover protrusion.

Remove the 3 bolts and crankshaft pulley.

• NOTICE:

• If the crankshaft pulley cannot be removed, temporarily install a bolt to the crankshaft so that the pulley does not fall, and lightly tap the outer edge of the mass damper with a plastic-faced hammer to remove the pulley. Do not tap the pulley V-ribbed belt ribs, as the crankshaft may be damaged.

Using a knife, cut off the lip of the oil seal.

Using a screwdriver, pry out the oil seal.

• NOTICE:

• Be careful not to damage the crankshaft.

• HINT:

• Tape the screwdriver tip before use.