Front Console Box (W/ Cool Box) Inspection

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
1 - 2	On	Below 1 Ω
1 - 2	Off	10 kΩ or higher

Apply battery voltage to the cooler control switch connector and check that the indicator illuminates.

OK:

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 3 Battery negative (-) → Terminal 4	indicator illuminates

Apply battery voltage to the blower motor connector and check the operation of the blower motor.

OK:

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2	Motor operates smoothly

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	-10°C (14°F)	7.40 to 9.20 kΩ
1 - 2	-5°C (23°F)	5.65 to 7.00 kΩ
1 - 2	0°C (32°F)	4.35 to 5.40 kΩ
1 - 2	5°C (41°F)	3.40 to 4.20 kΩ
1 - 2	10°C (50°F)	2.68 to 3.30 kΩ
1 - 2	15°C (59°F)	2.10 to 2.60 kΩ
1 - 2	20°C (68°F)	1.66 to 2.10 kΩ
1 - 2	25°C (77°F)	1.32 to 1.66 kΩ
1 - 2	30°C (86°F)	1.05 to 1.35 kΩ

NOTICE:

1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
   
2. When measuring, the sensor temperature must be the same as the ambient temperature.
   

HINT:

1. As the temperature increases, the resistance decreases (see the graph).
   
2. If the result is not as specified, replace the cooler thermistor.