Drive Belt - On-Vehicle Inspection

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV ENGINE MECHANICAL

DRIVE BELT - ON-VEHICLE INSPECTION

1. INSPECT V-RIBBED BELT
Drive Belt - On-Vehicle Inspection. 1VD-FTV ENGINE MECHANICAL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Check the belt for wear, cracks or other signs of damage.


If any of the following defects is found, replace the V-ribbed belt.

The belt is cracked.
The belt is worn out to the extent that the cords are exposed.
The belt has chunks missing from the ribs.

Check that the belt fits properly in the ribbed grooves.

  • HINT:
  • Check with your hand to confirm that the belt has not slipped out of the groove on the bottom of the pulley.
  • If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt.
2. INSPECT V-RIBBED BELT TENSION (w/ Viscous Heater)
Drive Belt - On-Vehicle Inspection. 1VD-FTV ENGINE MECHANICAL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Using a belt tension gauge, inspect the belt tension.

  • Standard Belt Tension:
  • ItemConditionSpecified Condition
    New belt5 to 35°C (41 to 95°F)550 to 800 N (56 to 82 kgf, 123.6 to 179.8 lbf)
    Used belt5 to 35°C (41 to 95°F)300 to 500 N (31 to 51 kgf, 67.4 to 112.4 lbf)
Text in Illustration
*aMeasuring Point
  • HINT:
When measuring the tension of a new belt, measure the tension immediately after installing it to the engine but before starting the engine.
A "new belt" is a belt which has been used for less than 5 minutes on a running engine.
A "used belt" is a belt which has been used on a running engine for 5 minutes or more.
After installing a new belt, run the engine for approximately 5 minutes and then recheck the tension.
3. INSPECT V-RIBBED BELT TENSIONER ASSEMBLY
Drive Belt - On-Vehicle Inspection. 1VD-FTV ENGINE MECHANICAL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Check that nothing gets caught in the tensioner by turning it clockwise and counterclockwise.


If a malfunction exists, replace the tensioner.