Dtc C1Aa0 Front Camera Module Circuit

Vehicle Interior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Pre-Crash Safety. Land Cruiser. Urj200, 202 Grj200 Vdj200

DESCRIPTION

INSPECTION PROCEDURE

CHECK DTC OUTPUT (FORWARD RECOGNITION CAMERA SYSTEM)

CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)

DTC C1AA0 Front Camera Module Circuit


DESCRIPTION

The driving support ECU assembly receives information about the area in front of the vehicle from the forward recognition camera. If the driving support ECU assembly detects a malfunction in the forward recognition camera, it stores DTC C1AA0.

DTC No.
DTC Detection Condition
Trouble Area
C1AA0
While the engine switch is on (IG), the forward recognition camera detects an internal malfunction for approximately 5 seconds or more.
  1. Forward recognition camera system
  2. Driving support ECU assembly

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
  2. When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
  3. If the forward recognition camera has been replaced with a new one or the windshield glass has been removed and installed, it is necessary to perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust (See page (Click here). If the system is turned on without performing Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust, DTC C1AA9 will be stored.
  4. First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.
    1. for LHD: Click here
    2. for RHD: Click here
1.CHECK DTC OUTPUT (FORWARD RECOGNITION CAMERA SYSTEM)

  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.

  1. Check for DTCs (Click here).

Result
Result
Proceed to
Forward recognition camera system DTCs are not output
A
Forward recognition camera system DTCs are output
B


B
GO TO FORWARD RECOGNITION CAMERA SYSTEM (Click here)
A


2.CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)

  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Pre-Crash 2 / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

  1. Check for DTCs (Click here).

Result
Result
Proceed to
DTC C1AA0 is not output
A
DTC C1AA0 is output
B


B
REPLACE DRIVING SUPPORT ECU ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (SYMPTOM SIMULATION) (Click here)