Spiral Cable Removal

Vehicle Interior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Supplemental Restraint Systems. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. PRECAUTION

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  4. REMOVE STEERING WHEEL ASSEMBLY

  5. REMOVE LOWER STEERING COLUMN COVER

  6. REMOVE UPPER STEERING COLUMN COVER

  7. REMOVE SPIRAL CABLE SUB-ASSEMBLY

  8. REMOVE SPIRAL CABLE (w/ Steering Angle Sensor)

Spiral Cable -- Removal


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE STEERING WHEEL ASSEMBLY
(Click here )


5. REMOVE LOWER STEERING COLUMN COVER
for Manual Tilt and Manual Telescopic Steering Column:
(Click here)
for Power Tilt and Power Telescopic Steering Column:
(Click here)


6. REMOVE UPPER STEERING COLUMN COVER
for Manual Tilt and Manual Telescopic Steering Column:
(Click here)
for Power Tilt and Power Telescopic Steering Column:
(Click here)


7. REMOVE SPIRAL CABLE SUB-ASSEMBLY

  1. Disconnect each connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Detach the 3 claws and remove the spiral cable sub-assembly.



8. REMOVE SPIRAL CABLE (w/ Steering Angle Sensor)
NOTICE:
  1. Remove the spiral cable from the steering sensor only when replacing it.
  2. Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in a misaligned center position of the steering sensor. Therefore, make sure to use the lock pin provided with a new spiral cable when removing the steering sensor from the spiral cable sub-assembly.


  1. Install the lock pin to the steering sensor.

    NOTICE:
    1. Use the lock pin provided with a new spiral cable.
    2. Do not remove the lock pin before the spiral cable is installed to the steering sensor.


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Supplemental Restraint Systems.Airbag System.Spiral Cable Removal



    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Detach the 6 claws and remove the spiral cable from the steering sensor.