Meter / Gauge System Voltage Meter Malfunction

Vehicle Interior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Meter Gauge Display. Land Cruiser. Urj200, 202 Grj200 Vdj200

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

INSPECT FUSE (MET)

PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VOLTMETER)

CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)

METER / GAUGE SYSTEM - Voltage Meter Malfunction


DESCRIPTION

The voltmeter indicates the voltage applied to the IG+ terminal of the combination meter.

WIRING DIAGRAM


Land Cruiser. Urj200, 202 Grj200 Vdj200.Meter Gauge Display.Meter / Gauge System.Meter / Gauge System Voltage Meter Malfunction


INSPECTION PROCEDURE

1.INSPECT FUSE (MET)

  1. Remove the MET fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    MET fuse
    		Always
    		Below 1 Ω


NG
REPLACE FUSE
OK


2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VOLTMETER)

  1. Operate the intelligent tester according to the display and select Active Test (Click here).

    Combination Meter
    Tester Display
    		Test Part
    		Control Range
    		Diagnostic Note
    Volt meter Operation
    		Voltmeter
    		0, 3, 6, 9, 12, 15, or 18
    		Perform the test with the vehicle stopped and engine idling.
    OK:
    Needle indication is normal.
    Result
    Result
    		Proceed to
    OK
    		A
    NG (w/ Multi-information Display)
    		B
    NG (w/o Multi-information Display)
    		C


B
REPLACE COMBINATION METER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)
Land Cruiser. Urj200, 202 Grj200 Vdj200.Meter Gauge Display.Meter / Gauge System.Meter / Gauge System Voltage Meter Malfunction

  1. Disconnect the E7 meter connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    E7-15 (ET) - Body ground
    		Always
    		Below 1 Ω
    Standard Voltage:
    Tester Connection
    		Switch Condition
    		Specified Condition
    E7-18 (IG+)
    		Ignition switch ON
    		11 to 14 V
    Ignition switch off
    		Below 1 V
    Result
    Result
    		Proceed to
    NG
    		A
    OK (w/ Multi-information Display)
    		B
    OK (w/o Multi-information Display)
    		C


B
REPLACE COMBINATION METER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR